Squier JMJM Jazzmaster bridge and tail replacement.

[broomhandle]

Hello,

I know this has been talked over and over. The bridge on the original is a 9.5 and everything else is a 12" radius. Is there anything that is a direct fit with a 9.5? I was looking at this but it is 12"

Gotoh Tune-o-matic Bridge with Studs/Bushings - StewMac

A modern tune-o-matic bridge for solidbody guitar.

www.stewmac.com

And I am not sure if it has the correct size holes.

I would also like to replace the trem/tail with fender. Does our squires fit the mex, usa or Japan plate? I think it is USA/MEX and not Japan.

thanks.

 

[Big tuna]

Just measure the holes in body The gotoh says 11mm holes so check depth for match and there you go.

 

[broomhandle]

Just measure the holes in body The gotoh says 11mm holes so check depth for match and there you go.

what about 12 hrs 9.5 radius? Is the original bridge 9.5 or 12?

 

[dpang2836]

Gotoh makes one with the two height adjustment screws on each Saddle. Pick up the Radius that way, if not the same.